Sump Pump Repairs & Installations

Sump pumps typically last between 7 and 10 years, depending on the quality of the pump, usage, and maintenance.

To replace a sump pump, follow these steps:

• Disconnect power to the old sump pump.
• Remove the discharge pipe from the pump.
• Lift the old pump out of the sump pit.
• Clean the pit and inspect it for damage or debris.
• Install the new sump pump and attach the discharge pipe.
• Make sure the float switch is positioned correctly.
• Reconnect power and test the new pump for proper operation.

The frequency at which your sump pump runs depends on the level of groundwater around your home and the amount of rain you receive. It's normal for a sump pump to run more frequently during heavy rainfall or periods of snowmelt.

To clean a sump pump, follow these steps:

• Disconnect power to the pump.
• Remove the pump from the pit.
• Clean the pump and its components, such as the impeller and the screen, using a hose and a brush to remove any debris.
• Inspect the pump for any signs of wear or damage.
• Reinstall the pump, reconnect power, and test for proper operation.

A sump pump may keep running due to a stuck float switch, a malfunctioning check valve, or excessive water infiltration into the pit.

To test your sump pump, pour a bucket of water into the sump pit, and the pump should activate automatically. If it doesn't, check the power supply and the float switch.

A sump pump can typically run continuously for several hours, depending on the pump's capacity and the amount of water it needs to remove. However, running continuously for extended periods can cause the pump to overheat and shorten its lifespan.

A loud sump pump may be caused by a clogged or damaged impeller, a failing motor, or vibrations from the pump touching the sides of the pit or the discharge pipe.

To reset a sump pump, first, unplug the pump from the power source, wait a few minutes, and then plug it back in. If the pump still doesn't work, consult the manufacturer's instructions for any specific reset procedures or troubleshooting steps.